Group and project settings
A group's or project's settings decide how agents work there: which agents, which commands a new worktree runs, and when an agent run's work counts as done. Open Settings… on the ⋯ menu of a group, or of a project in no group. A project in a group uses its group's.
The settings are saved on this computer, because they name accounts and commands on it. They never travel with a shared workspace. Only the Memory section is saved in the workspace.
| Section | What it sets |
|---|---|
| Folder | Shows the folder on this computer. Change it with Change folder on the ⋯ menu |
| Agents here | Which agents this project uses. None ticked: the workspace's. Save agents saves. Accounts and models are set in Connect → Agents |
| New worktrees | Set up, Preview, On remove and Carry over commands (Worktrees) |
| Done means | The Check command that decides an agent run's work is done, Autopilot, and the Rules agent runs follow here (Agent runs, Agent run rules) |
| Work from | The sources whose tasks start here (The start dialog) |
| Project hooks | Shown when the project's own agent settings run commands at the start of a turn. Until you press Allow this project's hooks, turns below Full auto are refused here. A change to those settings asks again |
| Memory | What Uniloom keeps from this project (What a project keeps) |
Fields save when you leave them.
Last updated